Filter
Top Products
Detergent dispenser drawer
Compartment for prewash or soak detergent and stain remover. The prewash
or soak detergent is added at the beginning of the wash programme. The
stain remover is added during the STAIN-Action phase in the main wash.
Compartment for powder or liquid detergent used for main wash.
It is emptied at the beginning of the wash cycle.
Compartment for liquid additives (fabric softener, starch).
It is emptied at the last rinse.
The quantity of additives must not exceed the “MAX” mark in the
drawer.
Before the first wash
Before your first wash, we recommend that you run a cotton cycle at
60°C, without any laundry in the machine, to remove any manufac-
turing residue from the drum and tub.
Pour 1/2 a measure of detergent into the dispenser drawer and start the
machine.
Programme chart
17
Cancelling a programme
To cancel a programme which is running, turn the programme selector
dial to the ANULACION (RESET)position: three flashing dashes will be
displayed.
Warning! After a programme which ends with water in the drum
(RINSE HOLD option), turn the selector dial first to ANULACION
(RESET)and then to the PUMP OUT programme.
Altering a programme which is running
To alter a programme, first set the machine to PAUSE by pressing the
START/PAUSE button.
Before the machine starts the heating phase, i.e. within the first 15
minutes for cotton programmes, 10 minutes for synthetic and delicate
programmes and 5 minutes for the wool programme, the selected wash
cycle can be modified.
Warning! If the programme selector dial is turned first to ANULACION
(RESET)and then to the new programme, the programme which is running
is cancelled, the water is emptied out and the machine re-starts from
water filling. To simply modify the programme which is running, turn
the programme selector dial to the desired position (avoiding the RESET
position): when the START/PAUSE button is pressed again, the machine
restarts with the newly selected programme from the point at which it was
interrupted.
Opening the door after the programme has started
The door can only be opened before the machine starts the heating
phase (within the first 15, 10 or 5 minutes, depending on the pro-
gramme selected - see paragraph above) and during the rinse phase.
Set the machine to PAUSE (by pressing the START/PAUSE button).
If the door does not open, this means that the machine is already heat-
ing, or that the water level is above the bottom edge of the door.
This prevents water from spilling out when the door is opened.
16
Description of the appliance Description of the appliance