Filter
Top Products
How to dry
Drying only
Warning! Do not exceed the maximum laundry loads:
- 2.5 kg for linen and cottons
- 2 kg for synthetics.
The water tap must be open and the drain hose must be positioned in
the sink or connected to the drain pipe.
Depress the ON/OFF button to switch the machine on.
Select the drying programme (for cotton or synthetics).
Depress the DRYING TIME button until the time you
want appears in the display (for timed drying).
If you wish to carry out the electronic drying, depress
the button corresponding to the degree of dryness
required.
Press the START/PAUSE button to start the programme.
At the end of the cycle, turn the programme selector
dial to ANULACION and press the ON/OFF button
again to switch the appliance off.
Remove the laundry.
Automatic washing and drying
(NON-STOP programme)
Warning! For NON-STOP programmes, it is also essential not to exceed
the maximum load sizes of 2.5 kg for cotton and 2 kg for synthetics.
If you use a dosing device in a washer-dryer, please ensure the dosing
device/ball is removed before carrying out a drying programme.
Load the laundry.
Add detergent and additive.
Switch the machine on by depressing the ON/OFF button.
Select the wash programme.
Select eventually the required options by means of the relevant buttons.
If possible, do not select a spin speed lower than that proposed by the
appliance to avoid a too long drying time so saving energy.
Select the drying time or degree of drying.
Start the programme by depressing the START/PAUSE button.
At the end of the programme, turn the selector dial to ANULACION and
press the ON/OFF button again to switch the machine off.
Remove the laundry.
29
At the end of the programme
The machine stops automatically and three flashing zeros are displayed.
The FIN (END) and spin speed pilot lights, as well as the pilot light(s)
corresponding to the selected option(s), stay on.
If the RINSE HOLD option has been selected, the corresponding pilot
light on the programme progress display flashes to indicate that the
water must be emptied out before opening the door.
The pilot light of the START button flashes and tree flashing zeros are
displayed.
Release of the lock is indicated by an audible signal.
Turn the programme selector dial to ANULACION (RESET).
Switch the machine off by pressing the ON/OFF button.
Remove the laundry from the drum.
Check that the drum is empty so as to avoid a subsequent wash being
damaged by any forgotten items.
Close the water tap.
Leave the door open to prevent the formation of mildew and unpleas-
ant smells.
28
How to wash
TIEMPO DE
SECADO
SECO
ARMARIO
SECO
PLANCHA