Filter
Top Products
Water inlet (cold water connection only)
Connect the hose
to a tap with a
3/4” thread.
Installation
should comply
with local water
authority and
building regula-
tions’ require-
ments.
Set the hose correctly by loosening the ring nut. After positioning the
inlet hose, be sure to tighten the ring nut again to prevent leaks.
Do not connect to a hot water supply.
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window “A”. Should this occur, turn the
water tap off and refer to your Service Force
Centre to replace the hose.
Water drainage
The appliance drain hose should hook into a standpipe, the hook in the
drain hose is formed using the plastic “U-Piece” supplied. The standpipe
should have an internal diameter of approximately 38 mm (see dia-
gram) thus ensuring there is an air break between the drain hose and
standpipe.
When discharging into a stand-
pipe ensure that the top of the
curve in the hose end is no
more than 90 cm (35.4”) and
no less than 60 cm (23.6”)
above floor level.
45
Installation
A
3 pin
Max. 90 cm.(35.4")
Min.60 cm.(23.6")
132996260.qxd 7/24/01 9:12 PM Pagina 45 (Nero/Process Black pellicola)