Filter
Top Products
12
Cycles, options, lights
W
hat can & cannot be
w
ashed
o
perating tips
d
ishwasher use
loading
C
ontrols at a glance
D
ryer Exhaust tips
S
afety
C
are & Cleaning
S
ervice & Warranty
Surface Cooking
t
roubleshooting
O
ven Cooking
Storing the washer
Installation
S
pecial Features
Notes
Troubleshooting
• Plug cord into live electrical outlet.
•
Check fuse or reset circuit breaker.
• Turn the control dial to proper cycle and restart the washer.
• Turn both faucets on fully.
• Straighten inlet hoses.
• Disconnect hoses and clean screens. Hose filter screens may be plugged.
• Check fuse or reset circuit breaker.
• Make sure the lid is completely closed.
• Turn the control dial to proper cycle and restart the washer.
• Pauses are normal. Wait and see if the washer will start again.
• Check fuse or reset circuit breaker.
• Straighten drain hoses. Eliminate kinked hoses. If there is a home drain restriction, call for
drain service.
• Close lid and restart the washer. For your safety, washer will not spin unless the lid is closed.
• Suds lock – caused by too much suds. Rewash without detergent. Use correct amount of a
low-sudsing detergent.
• Unevenly distributed load. Redistribute the load, close the lid and restart the washer. Check for
leveling. Be sure water level is acceptable for load size.
• A normal spin speed is recommended for heavy loads like jeans or towels.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Close lid and restart the washer. For your safety, washer will not agitate or spin unless lid is closed.
• This may be a pause in the cycle. Wait briefly and it may start.
• Make sure hose connections are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended soaking – soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation manual.
• Weak floors can cause vibration and walking.
• Operating sounds will vary depending on agitation speed.
• Turn both faucets
on fully.
• If equipped with a temperature selector dial, be sure it is set directly on a temperature setting and
not between settings.
• Make sure temperature selection is correct.
• Make sure hoses are connected to correct faucet
s and inlet connections. Be sure water supply is
regulated correctly. Flush water line before filling washer.
• Check the water heater. It should be set to deliver a minimum 120° F (49° C) hot water at the tap.
Also check water heater c
apacity and recovery rate.
•
Disconnect hose
s and clean screens. Hose filter screens may be plugged.
•
E
X
TR
A RINSE
(select models) is selected.
W
on’t Fill
Won’t Agitate
Won’t Spin
or Drain
Load is Wet
Stops
Leaks Water
Is Noisy
Fills with
the Wrong
Temperature
W
ater
Cy
cl
e Selector
Advances Through
Off