Filter
Top Products
63
9. Exceptionally cold/humid or low barometric pressure atmosphere.
10. Cycle temperature thermostats are covered with lint
NOTE: Lint accumulation on the sensor bracket can act as an insulator which will affect the
accuracy of the Automatic Drying Cycle.
K. Main burners are burning with a yellow flame (for Gas Models ONLY)...
1. Poor air/gas mixture (too much gas or not enough air) at the burner ...
a. Not enough make-up air.
b. Restriction in the exhaust.
c. Gas pressure is too high.
d. Impellor (fan/blower) is rotating in the wrong direction only (for 3ø Models ONLY).
e. Burner orifice size (D.M.S. [drill material size]) too large for application (i.e., high elevation).
L. Condensation on main door glass...
1. Too long, undersized, or improperly installed duct work.
2. Back draft damper is sticking in the partially closed position.
M. Scraping noise at basket (tumbler) area...
1. Check for obstruction caught in basket (tumbler)/wrapper area.
2. Basket (tumbler) is out of proper alignment ...
a. Check both the vertical alignment and lateral alignment.
b. Check for gap between the front panel and basket (tumbler)...bearing set screws may have come
loose, and basket (tumbler) walked forward or backward.
3. Loose basket (tumbler) tie rod.
4. Failed basket (tumbler) support.
N. Excessive noise and/or vibration...
1. Dryer is not leveled properly.
2. Impellor (fan/blower) out of balance ...
a. Excessive lint build up on impellor (fan/blower).
b. Failed impellor (fan/blower).