Filter
Top Products
45
N. PROGRAM LOCATION 11 (PL11)
Time For Amount To Start
Location to be viewed/changed.
Press “Perm Press” key.
Upper display will read “tFAS” (Time
For Amount To Start) and the lower
display will read the actual amount
programmed. If no change, press the
“PERM PRESS” key, otherwise press
the “HI TEMP” key or the “LO
TEMP” key and then press the “PERM
PRESS” key.
Summary: The time for amount to start is programmable from 1 to 99 minutes.
PL11
tFAS
Perm Press
4 HI Temp
Perm Press
LO Temp
Refer to
Section V
for instructions
on entering program locations.
(Wait 3-Seconds)
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL12
Proceed to next location
to be changed
To exit program mode,
open program switch
Time Decrease
Time Increase