Filter
Top Products
44
M. PROGRAM LOCATION 10 (PL10)
Right Coin Denomination
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “rCdE,” right coin
denomination for 3-seconds and the
right coin acceptor denomination
programmed (I.E. 25¢). If no
change, press “Perm Press” key,
otherwise press “HI” or “LO”
keys and then “Perm Press” key.
Summary: The right coin denomination is programmable from 1 to 9999.
IMPORTANT: When the dryer is equipped with a dual coin acceptor, the value set here is the higher
value denomination, which is not necessarily the right coin portion of the acceptor.
NOTE: For single coin models this parameter need not to be set.
PL10
rCdE
Perm Press
25 HI Temp
Perm Press
LO Temp
Refer to
Section V
for instructions
on entering program locations.
(Wait 3-Seconds)
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL11
Proceed to next location
to be changed
To exit program mode,
open program switch
Amount Decrease
Amount Increase