ADC AD-410 Clothes Dryer User Manual


 
93
i. Tilt Switch Replacement
1) Discontinue electrical service to the dryer.
2) Remove the base panel from the left hand side of the dryer.
CAUTION: DO NOT PLACE HANDS BETWEEN THE DRYER BASE AND THE
TUMBLER (Basket/Drum) SECTION. SERIOUS INJURY CAN RESULT.
3) Unscrew tilt switch.
4) Loosen and remove the two (2) screws securing the junction cover.
5) Remove the junction cover.
6) Loosen and remove the two (2) mounting screws.
7) Loosen and remove cord grip cap.
8) Remove cord grip.
Verify that the body orientation
and the head orientation are
correct.
Verify that the tilt switch arm is not
in the vertical position or
damage
will result.
h. End of Cycle Light Replacement
1) Discontinue electrical service to the dryer.
2) Loosen and remove the cap screw on the top of the cap.
3) Remove the cap.
4) Loosen and remove the screw going into the lens.
5) Twist out lens and remove bulb/light.
6) To install new bulb, reverse above procedure
9) Place pivot arm in the 1 o'clock position
for the front tilt switch and in the 11 o'clock
position for the rear tilt switch