Zebra S400 & S600 User’s Guide 13
5HPRYLQJWKH/DEHO%DFNLQJ0DWHULDO
(Peel-Off option required).
When the amount of backing wound on the backing rewind spindle
reaches full capacity, the backing rewind spindle full sensor activates, the
PAPER/RIBBON light flashes, and printing pauses.
To remove the backing material, follow these steps (you don’t need to
power off the printer for this procedure):
1. Unwind about 24" of backing from the backing rewind spindle and cut
it off at the spindle.
2. Pull out the hold down hook and slide the backing material off of the
spindle and discard.
3. Feed the new starting edge of the backing through the mechanism and
attach it to the backing rewind spindle as described in the loading
procedure.
NOTE: While holding the media in position against the tear-off/
peel-off plate, open and close the printhead without disturbing the
media position. The printer is now ready to print more labels.
