SIGHT INSTALLATION
Front Sight: Eight separate front sight inserts are
provided with your vernier sight on a special sheet of
spring steel (Figure 2). Carefully break each sight
insert from the sheet by holding the entire insert
firmly between your thumb and forefinger. Work the
insert back and forth gently until it cleanly breaks
from the sheet. A plastic container is provided for
storage of front sight inserts after they are separated.
Remove the sight retaining ring from the front sight
body by turning its knurled end counterclockwise
(Figures 3A and 3B). Select which sight insert you
wish to use and place it in the sight body. The sides of
each insert are designed to fit snugly into the notches
in the sides of the front sight body.
Before rethreading the sight retaining ring into the
sight body, firmly snug the insert completely in the
front sight body or damage to the insert will occur.
Replace the retaining ring and tighten it firmly against
the insert.
To remove an insert from the front sight body,
remove the retaining ring, then gently pick the insert
out with a small screwdriver, being careful to not
damage either the insert or the sight body.
The front sight body is adjustable for windage and
also features a small bubble level to indicate when the
rifle is perfectly level, helping to eliminate
unwanted canting.
1
1
FIGURE 3A
FIGURE 3B
1: Sight Insert 2: Front Sight Body 3: Right Adjustment Screw
4: Left Locking Screw 5: Front Sight Retaining Ring 6: Bubble Level
1
2
4
6
5
3
