Performance Data Sheet @
Q
This Reverse Osmosis System has been tested and listed by NSF International
under Standard 58 for the water treatment claims listed below under
“Contaminant Reduction Performance”.
Whirlpool Reverse Osmosis Water Filtration System IV
Model No. WSR413YW
Test Parameters
TDS = 200500 mg/L2 pH = 7.5
Turbidity = 1 NTU Temperature = 77°F
Pressure = 50 psig
‘USEPA Maximum Contaminanl Level or Action Level (mg/L).
3arrium. Cadmium and Chromium were tested at 750 mglL TDS.
3The reduction of Radium was verified by using Barium as a surrogate under NSF prolocol.
‘These conlaminanls are not necessarily in your water supply. Periormance may vary based on local water conditions
In addilion to the contamlnanls listed above. these systems also have Ihe ability to effectively reduce non health-related chemicals
llke Chlorides, Phosphate, Sodium and Sulfates
I
APPLICATION GUIDELINES/SPECIFICATIONS AND FEATURES
Membrane TvDe 1
TFCM
I
Water SUDDIV Parameters
Water Supply-Community
or Pnvate Well
Chlorinated
Onlv
I
Chemical
Limit
Hardness ~350 ma/L
I
Water Pressure 1 40-l 00 psi (3-7 Kg/cm2) 1
Iron 1 co.1 mg/L I
Water Temperature 1 40”-100°F (4.4 - 36°C) 1
Manganese co.05 mg/L
DH Ranoe
4-11
I
Hvdroaen Sulfide
I
0
I Maximum TDS Level I
2000 ppm
I
Turbidity I cl NTU I
CAUTION: Da Not usa where water is microbiologically unsaie or with water of unknown quality
Waler supplies that exceed limits lor Hardness, Iron, Manganese. Hydrogen Sulfide require pretreatment.
I
Important Quality Assurance Requirements
This Reverse Osmosis Drinking Water system contains treatment components that are
critical for effective reduction of Total Dissolved Solids as well as inorganic contaminants.
A water quality monitor (indicator light disk) is build into the system to provide the user with a
means to test the water at any time. Refer to “Use and Care Information” for operation of the
water quality monitor (indicator light disk).
Routine Maintenance
Sediment Prefilter, Carbon Prefilter and Carbon Postfilter: Change once per year’
Membrane: Change as required based on the built-in water quality monitor.
*Refer to “Use and Care Inlormation” for additional conditions.
Purification Assembly Components
General Performance
Sediment Prefilter: 5 micron Nominal Depth
Testing Laboratory’
Cartridge
System Production: 10.3 gal/day (39 liters/day)
Carbon Prefilter: Activated Carbon
Minimum TDS Reduction: 96%
Membrane Type: Thin Film Composite (TFCM)
‘Raed at 50 psi, 77°F. 750 mg/L N&I, product to storage tank.
Carbon Postfilter: Activated Carbon
Standard Tank Capacity: 2.6 Gallons maximum.
Factory Specifications**
Factory sanitized and ready to install.
Membrane Production: 14-20 gal/day High-
Reject Water: This drinking water appliance has a
Flow Membrane
self cleaning feature that requires approximately
Membrane TDS Reduction: 96% Minimum
3 gallons of rinse water for every gallon of high
“Rated at 60 psi, 77°F. 350+ mglL TDS, product lo atmosphere.
quality water used.
Note: Actual produtiion rate and TDS reduction will depend
upon temperature. water pressure. TDS level, membrane
variation and usage pattern.
All Drinking Water Appliances are factory tested, sanitized and prepared for installation.
WARRANTY
Length of Warranty:
One Year Full Warranty
(from date of purchase)
Whirlpool will pay for:
Replacement parts and repair labor to correct defects
in materials or workmanship for the entire product
except for the filter cartridge(s). Servicing must be
provided by an authorized Whirlpool servicing outlet.
Five Year Limited Warranty
(second through fifth year
from date of purchase)
Whirlpool will not pay for:
A. Service calls to:
Replacement parts to correct defects in materials or
workmanship for the entire product except for the
filter cartridge(s).
1.) Correct the installation of the product. System must be installed and operated in accor-
dance with Whirlpool procedures and guidelines.
2.) Instruct you how to use the product.
3.) Correct house plumbing.
El. Repairs when product is used in other than normal, single-family household use.
C. Repairs when product is damaged from neglect, misuse, abuse, freezing or hot water, fouling
with sediment or scale, bacterial attack, alterations, improper installation, or installation not in
accordance with local plumbing codes.
D. Any labor costs during the limited warranty.
E. Replacement parts or repair labor costs for units operated outside the U.S.
F. Pickup and delivery. This product is designed to be repaired in the home.
G. Repairs to parts or systems caused by unauthorized modifications made lo the product.
The performance and functioning of your water filtration system is directly related to the quality of
the water being treated and the particular application in which it is used. Please consult “Water
Requirements” and “Use & Care”.
Whirlpool shall not be liable for Incidental or consequential damages. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so this limitation or exclusion may
not apply to you.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
17
