Th e cont rol p ane l can be clea ned by using a lightly dampen ed cloth.
Aft er cle anin g, make sure to dry it thoroug hly.
For t he e xteri or, use a g ood appli ance po li s h wax .
Never use sharp object s, scouri ng pads o rh arsh c leaners on any part of the dishwa sher.
Protect Again st Freezing
1.Cutoffthe electrical power to the dishwasher.
2.Turn off th ew at er suppl y and dis connec t the wat er inl et pipe from the water val ve.
3.Drainthewater fromthe inlet pipe andwatervalve. (Use apan to catchthewater)
4.Reconnect the water i nlet pi pe to the wa ter valve.
5.Remove the filter at the bott omo f the tub and use a spong et o soak up water in the sump.
pl ease take frost protect ion meas ures ont he di shw asher in winter. Ev ery fter wa shing cycles,
pl ease operate as follow s
time a
：
Caring for the Dishwasher
- Inspect t he filter sfo r blo cking after e very time th edi shwa sher has been used .
- By unscrew ing t he coar sefi lter, you can remove t he filter syst em . Re mov ean yf oo dre mna nts and
cleanthefilters underrunningwater.
Remarks:
Cleaning the Filter
Cleaning The Door
To c le an th e co a rs e f ilter and the fine f i l t e r, use a c l ean i n g bru sh. Re as sem ble the filter par t s as s hown in th e f i gur es
on th e last pa ge and r eins ert t he enti re ass emb ly in the dis hwa sher, po s itio nin g it in i ts seat and pressing dow nwar ds.
The entire filter assembly should be cleaned once a week.
When cleaning the filters, don't knock on them. O therwise, the filters could be
contorted and the performance ofthe dishwashercouldbe decreased.
WARNING!
To cle an thee dge ar ound the door, you should use only a soft warm, d am p cloth.
To avoi d pene trat iono f wa ter into the door lock and el ectrical componen ts, do not
use a spray cle aner of any ki nd.
WARNING!
Never use a spray c leaner t ocl ean the door panel as it may dam age the door loc k
and electrical components.
Abr asive agent sor some paper towels shou ldnot b e used because of th eris ko f
sc r a t c hi ng or le av in g s pots on th e st ainles s stee l s urf a ce.
Cleaning the SprayArms
It is necessary to clean the spra y arms regul arly in order to
remove the accum ulation of scale from the hard wat er
and thus pre vent blocki ng of spray arm jets and bearin gs.
We Suggest to poke the blocked spr ay arm jets with a needle
to ensure good w ashing effect .
15
I f you r dis hwa sher ca nnot w or k be cau s e of t he ic e, p l e a se c onta ct p ro fe ss io nal s erv ic e p er so ns.
Unscrew
