VCH & VRT SERIES OVENS F-41162 (07-10)
8
4. Turn ADJ/SET Knob to desired
cook temperature.
5. Push ADJ/SET Knob to set
cooking temperature.
Hold Temp. starts blinking.
6. Turn ADJ/SET Knob to desired
holding temperature.
7. Push ADJ/SET Knob to set
holding temperature.
8. Push the Start Button.
SETTING ADJUSTMENT
At any time you can adjust the setting
by:
1. Push the ADJ/SET Knob until
the desired setting flashes.
2. Turn the ADJ/SET Knob to
desired time/temperature.
3. Push the Start Button to set
your changes.
QUICK CYCLE
The Oven is programmed with default
settings of 100⁰F for the Cooking
Temperature and Holding Temperature.
To start Quick Cycle:
1. Switch ON/OFF Switch to ON.
2. Press START Button.
PRE-PROGRAMMED CYCLES
The Oven can be programmed for 9
cooking/holding cycles. To program
each cycle, P-1 through 9, use the
following instructions.
PROGRAMMING:
From the “Idle State” while the Time is
blinking:
1. Press and Hold the ADJ/SET
Button for 3 seconds. The time
will no longer blink.
The Cabinet Temp. will display
“P-1” and is blinking. If P-1 is the
desired cycle, go to step 3.
2. If P-2 through 9 is the desired
cycle, Rotate the ADJ/SET
Knob to the desired pre-
programmed cycle.
3. Press and Hold the ADJ/SET
Knob for 3 seconds.
Time will start blinking.
4. Rotate the ADJ/SET Knob to
desired time.
5. Press the ADJ/SET Knob to
accept the time.
Cook Temp. will start blinking.
6. Rotate the ADJ/SET Knob to
desired cooking temperature.
7. Press the ADJ/SET Knob to
accept Cook Temp.
Hold Tem. will start blinking.
