Chapter 2: Easy Setup
20 ViewCast
Easy First Time Setup
You should read all instructions, notices, and warnings before getting started with your new Niagara
2120 hardware for the first time. Also, ensure you have all required parts and meet all system
requirements before installing this product.
Do not continue with the installation if you find any components missing or damaged. Contact the
ViewCast reseller where you purchased your Niagara 2120 system for assistance in obtaining any
missing or replacement parts.
Connecting to an Electrical Power Source
Niagara 2120 ships with one of the following power cables:
North America power cable
International power cable
UK power cable
Follow the steps in Table 6 to connect your power source to the Niagara 2120.
Table 6. Connect the Power Source
Attach the block end to the power cable that comes with the equipment.
Connect the adaptor to the unit 12 VDC input located on the upper back panel
corner of the Niagara 2120.
WARNING! The plug-socket combination must remain accessible at all times as it
serves as the main disconnecting device.
Do not work on the system or connect or disconnect cables during periods of lightning
activity.
