CLR2060 — Clear Ice Maker
www.U-LineService.com 10 02/2005
™
4. Attach the door panel to the overlay panel using #10 x
5/8" wood screws and nylon spacers. The nylon spacers
fit between the overlay panel and the door panel as
shown in
Figure 22
. The spacers
allow the original
door panel to slide back into the
1/4"-thick door
reveal (channel).
5. Remove the existing bottom pivot plate and replace
with the Full Overlay pivot plate (see
Figure 23
).
IMPORTANT
Door panel and overlay panel must be aligned properly or
the door will not operate correctly.
Assembling the Door
1. Install the assembled panel by sliding the original door
panel back into the doorframe.
2. Replace the two-piece Modified Handle assembly and
secure with the two screws removed in Step 5 under
Removing Existing Door.
3. Starting at the corners and working toward the center,
push the door gasket back into place.
Installing the Door
1. Remove the existing hinges from the unit, saving the
door closure assembly.
2. Install the new Replacement Top Hinge onto the unit
(see
Figure 24
).
Removed
Door Panel
Bottom of
Wood Panel
Back of
Wood
Panel
Side of
Wood Panel
Tape
5/16"
Bottom
3/8"
Both Sides
Figure 20
Drill 5/32"
x
3/8" Deep for use
with #10
x
5/8" Wood Screw
and Nylon Spacer –
6 Places
1"
±
1/8"
1"
±
1/32"1"
±
1/32"
14-5/16"
±
1/4"
27"
±
1/4"
Rear View
of
Wood Panel
Figure 21
Door Panel
Top
Pivot Plate
Typical
Wood Panel
Plastic Spacer
Six Required
#10
x
5/8"
Round
Head Screw
Six Required
Figure 22
#8-32
x
3/8" SEMS Hex Screw
Two Places
Wood Panel Bottom Pivot Plate
(5/8" Longer Than
Existing Bottom Pivot Plate,
Flush Side Facing Out)
Existing
Door
Existing Bottom Pivot Plate
(Remove and Discard)
Figure 23
