15. Disconnect the RJ-45 cable and
unplug the power. Then plug the
power back in (TV-IP410W).
English
7
14. Click Site Survey. Select your
wireless network. If encryption
is enabled, select the proper
Authentication type, enter the
Pre-Shared Key and then click
apply. (Example shows
WPA2-PSK. If your wireless
network does not support WPA,
select open or shared instead.
Contact your network
administrator for more
information) (TV-IP410W only).
Note: The TV-IP410W will not work wirelessly until you disconnect the Ethernet
cable from the back of the camera.
13. Click Setup, Network and then
click Wireless. (TV-IP410W only).
