The computer must be set, or “programmed,” so that it gives its readout in the units preferred by the
user, and so that it calculates with the correct wheel size. There are three ways to use the buttons:
• Cycle- push repeatedly as needed
• Hold- push and hold in for two or three seconds
The method used to set the computer varies according to the computer model. Follow the instruc-
tions covering your computer model, grouped as follows:
• Incite 6i and 8i (pages 7-9)
• Incite 9i and 11i (pages 10-12)
Setting the 6i and 8i is done by pushing the two buttons in a specific sequence. The button on the
side of the computer is the
button. The large button on the bottom, which may look like two
To set Odometer and Wheel size
By default, the odometer always starts at ‘0’. If desired, the odometer can be manually set at another
to select measurement conversion.
to the preferred wheel size.
For a custom wheel size, see
To set a custom wheel size
for the first digit of Odometer.
9. Repeat steps 7 and 8 to select the other digits of Odometer.
The computer returns to current speed.
to select measurement conversion.
to the four-digit number (see Table 2).
Table 2- Wheel size and corresponding settings in millimeters
until the last digit flashes.
to your preferred value for the digit.
9. Repeat steps 7 and 8 to select the other three digits.
for the first digit of Odometer.
12. Repeat steps 10 and 11 to select the other digits of Odometer.
The computer returns to current speed display.
