Figure 13-9 Traps Config
The following entries are displayed on this screen:
SNMP Traps
SNMP
Authentication:
If selected, the switch will send an SNMP Authentication trap
when a received SNMP request fails the authentication.
Coldstart: If selected, the switch will send a Coldstart trap when it is rebooted
with the SNMP function enabled.
Warmstart: If selected, the switch will send a Warmstart trap when you enable
the SNMP function.
Link Status: If selected, the switch will send a Link Status trap when the
up/down status of the port changes.
CPU Utilization: If selected, the switch will send a CPU Utilization trap when the
CPU utilization rate is over 80%.
Memory Utilization: If selected, the switch will send a Memory Utilization trap when the
memory utilization rate is over 80%.
Flash Operation: If selected, the switch will send a Flash Operation trap when a
flash operation occurs. The flash operations include firmware
upgrading, system resetting, config restoring and config saving.
231
