4.7 System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card 4 Replacement Procedures
4.7 System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card
Removing the System Board, DC-IN, RJ-45 Cable and Blue-Tooth Card
NOTE: Be careful of the eject button for the PC card. It can be damaged when removing
the board. Make sure it is securely installed.
Remove the DC-IN, RJ-45 Cable and Blue-Tooth Card according to the following
procedures and Figure 4-15, 4-16.
1. Remove the DC-IN cable from CN5 on the system board.
2. Remove the RJ-45 cable from CN511.
3. Remove one M 1.6 x 4 black flat-head screw on Blue-Tooth card.
4. Remove the Blue-Tooth cable from CN10 on the system board.
5. Remove the Blue-Tooth Card on system board.
6. Remove the MIC rubber on the system board.
RJ45 cable
M1.6 x 4 black flat-head screw
Blue tooth card
Blue tooth rubber
CN10
MIC rubber
DC-IN cable
CN5
CN511
Figure 4-15 Removing the system board
TOSHIBA NB100 Maintenance Manual 4-27
