A SERVICE OF

logo

Open as PDF
next previous
15
CONNECTION AT A MULTI PROJECTION SYSTEM
Following is example of connection for a multi-projection system using four projection units.
In this example, signal sources are supplied into the Unit-1 and a signal selected by the Unit-1 is
supplied from Unit-1 to Unit-2 through Unit-4 with the Digital Signal Link.
The optional wired remote controller is connected to Unit-1 and all Units are controlled by the System
Bus Link.
AC Power Supply
RGB Input-1
RGB Input-2
Wired Remote
Control
Unit-4 Unit-3
Unit-1
Unit-2
OU T IN R GB 2 RGB 1DIGITAL SIGNAL LINK RGB INPUT
CONTROL RS-232C
INOU T
POWER FAN LAMP REMOTE
OU T IN R GB 2 RGB 1
DI GITAL SI GNAL L INK RGB INPUT
CONTROL RS-232C
INOUT
POWER FAN LAMP REMOTE
OU T IN R GB 2 RGB 1
DI GITAL SI GNAL L INK RGB INPUT
CONTROL RS-232C
INOUT
POWER FAN LAMP REMOTE
OU T IN R GB 2 RGB 1
DIGITAL SIGNAL LINK RGB INPUT
CONTROL RS-232C INOUT
POWER FAN LAMP REMOTE
VI DEOOU T IN VIDEOOUT IN
VI DEO
OU T
IN
VI DEO
OU T IN
Video Input
AC INLET
AC OUTLET
15A 125V/250V AC
AC100V-240V 50/60Hz
UNSWITCHED MAX 10A
AC INLET
AC OUTLET
15A 125V/250V AC
AC100V-240V 50/60Hz
UNSWITCHED MAX 10A
AC INLET
AC OUTLET
15A 125V/250V AC
AC100V-240V 50/60Hz
UNSWITCHED MAX 10A
AC INLET
AC OUTLET
15A 125V/250V AC
AC100V-240V 50/60Hz
UNSWITCHED MAX 10A
AC Power Supply
AC Power SupplyAC Power Supply
Note: Maximum number of units which can be connected via Digital Signal Link is dependent on input
signal quality including S/N and jitter, etc.