4.19 Display Assembly 4 Replacement Procedures
Installing the Display Assembly
To install the display assembly, follow the steps below and refer to the figures in the
preceding section.
1. Seat the display assembly taking care not to crush to the LCD display cable or
wireless LAN antenna.
2. Feed the wireless LAN antenna through the system board into the wireless LAN
compartment.
3. If a wireless LAN card is installed, remove the wireless LAN compartment cover
and attach the ends of the wireless LAN antenna to the card. The black antenna
cable should be attached to the connector nearer the rear side of the computer, the
white antenna cable to the connector closer to the front panel.
4. Secure the hinges with two M2.5×6 screws. Use the same screw to secure the
display cable to the left side hinge.
5. Attach the display cable to its connector on the system board.
6. Seat the hinge cover and secure its top-side with one m2.5×12 screw at the left end
and one m2.5×3 silver screw at the right end.
7. Secure the hinge cover with one M2×4 screw at the rear of the each hinge.
8. Secure the display assembly with two M2.5×6 screws on the I/O cover.
Satellite P20-25 Series Maintenance Manual 4-57
