15
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Occasionally
resetting the system can return the camera to normal operation. If the system problems remain
after resetting, restore the factory settings and install again.
Reset:Hold for about 3 seconds and release the recessed reset button with a paper clip or small
object. Wait for the Network Camera to reboot.
Restore:Press and hold the recessed reset button until the status LED rapidly blinks. It takes
about 10 seconds. Note that all settings will be restored to factory default. Upon successful
restore, the status LED will blink during normal operation.
Status LED
The LED indicates the status of the Network Camera.
Restoring the factory defaults will erase any previous settings.
Item LED status Description
1 Steady Red Powered and system booting
Red LED off Power off
2 Steady Red Network failed
Red LED blinks every 1 sec.
(on for 1 sec. and off for
antoher)
Connected to network (heartbeat) and BRB
mode (Back Recovery Booting)
3 Blinks RED every 0.15 sec.
(on for 0.15 sec. and off for
another)
Upgrading rmware.
4 Blinks RED every 0.15 sec.
(on for 0.15 sec. and off for
another)
Restoring defaults.
