13
Hardware Installation
Follow the steps below to mount the Network Camera:
The Installation example is for reference only. Mounting bracket is not included.
1. Drill six pilot holes (φ0.24 inch x 0.37 inches(D)). And Hammer the plastic
anchors (not included) into the holes.
2. Align the six holes of the mounting Bracket (not supplied) with the six plastic
anchors, insert the appropriate screws (φ0.16 inch x 0.96 inches(D)) (not
included) to corresponding holes.
3. Secure the Mounting Bracket to the wall.
4. Mounting the Lens to the camera. Use the appropriate lens (not supplied).
5. Turn the camera to the desired position when install the camera to the Mounting
Bracket. And secure using a screw driver.
Example of Horizontal installation
NOTE
Since this camera is using a 2 megapixel sensor, the recommended lens is a 2
megapixel lens for 1/3 inch sensors.
Do not block the light sensor when using an auto iris lens.
When installing in high locations, take caution to secure the camera from falling and
causing possible injury.
Tie using Fixing Hole to prevent from unplugging of power cord or other
cable.
112 (4.41)
15 (0.59)
Wall
9.5 (0.37)
4 (0.16)
͝
6 (0.24)
80 (3.15)
1/4"-20UNC
UP
DOWN
LEFT
RIGHT
The mounting hole of camera is
tripod socket hole.
mm(inch)
