A SERVICE OF

logo

274
9.BLINKING GRAPHIC SYMBOLS
4.Jam Symbols (Cont.)
9
Finisher
<Hole Punch Unit>
Procedure for releasing the paper misfeed in the Hole Punch Unit. If the Hole Punch Unit is not installed,
this procedure is not necessary.
<Inserter Unit>
Procedure for releasing the paper misfeed in the Inserter Unit. If the Inserter Unit is not installed, this pro-
cedure is not necessary.
<Saddle Stitch Finisher>
Procedure for releasing the paper misfeed in the saddle stitch unit. If the Saddle Stitch Finisher is not
installed, this procedure is not necessary.
1
While pressing the button, separate the
finishing device from the equipment.
(See P.268 for cautionary points regarding separation/
installation and moving of the options.)
2
<Hole Punch Unit>
Open the cover of the Hole Punch Unit.
3
<Hole Punch Unit>
Rotate the knob to locate the triangle
mark within the indicated area on the
label.