A SERVICE OF

logo

Open as PDF
next previous
Introduction 17
Introduction
• Choose Upload to GPS Unit and press Next (make sure that ProMark2 is connected
to your PC and turned on). By default, MapSend tries to find a receiver on COM1. If
you connected the ProMark2 receiver to any other port, there should be a window
informing you that the receiver was not found. See this window below:
• Press Settings and the following window with available ports should appear:
• You can specify the port and press Test. Or you can press Autodetect and the
software will find the receiver and the port itself. Note, that the baud rate of the serial
link depends on the baud rate of the receiver. If you want to upload maps quickly, you
need to increase the baud rate in ProMark2. Then depending on what you chose (Test
Figure 1.19: ProMark2 Connection Error Message
Figure 1.20: Testing Connection to ProMark2