4. Place a packing piece under the fan to lift
INTRODUCTION
the rear of the fan clear of the workbench.
Before using this appliance please read all these
5. Loosen the cable clamp on the rear half of
notes and instructions carefully and famliarise
the baseplate.
yourself with the features of your new appliance. In
particular, please study the assembly instructions
6. Align the four lugs on rear half of the
before assembling your tower fan.
baseplate over the sockets on the front half
and push them together. Dress the cable under
UNPACKING
the two locating lugs.
Unpack all the items carefully and remove all plastic
wrappings from the component parts.
Check the fan carefully. If any items are damaged or
missing, please return the appliance for
replacement to the store you purchased it from, or to
your nearest Tesco store. Remember to take your
receipt. Retain the packing, or if you decide to
dispose of it, make sure that you do so with due
regard to any recycling provisions currently in force.
ASSEMBLY
1. Lay the fan down on a sturdy workbench or
table so that the front grill is facing up. Support the
fan at the head and along the body with suitable
pieces of the fan packing.
7. Tighten the rear half of the baseplate to the
base with the remaining two screws.
8. Make sure the cable is clear of the bottom
fan pivot. Allow a little slack in the cable and
then secure the cable clamp.
9. Tighten all the five screws.
2. Unwrap the five screws from the bag attached to
one of the base sections and keep them safe.
3. Align the front half of the baseplate over the
mounting lugs in the base and attach it to the fan
base with three screws. Leave the screws half tight.
TF11 Tower Fan User Guide
