Tap Adaptor
Nut
Mesh Filter
Feed
Valve
Tap
Adaptor
Nut
Water Tube
Tap
Adaptor
Figure B
Main Cold Water Line
1. Separate the nut from the tap adaptor.
(Figure A)
2.
As shown in the figure, assemble the tap
adaptor to 1/2” valve fitting (Figure B)
3.
As shown in the figure, after inserting the
water pipe to the nut, install it to the tap
adaptor and insert to the tap as shown in the
figure. (Figure C)
4.
Tighten the nut manually. In case of a
leak use a spanner or a pair of pliers to
tighten the nut.
Caution: Secure the water pipe to suitable
points by means of the pipe clips supplied
to avoid any damage or displacement or
accidental disconnection.
Caution: After turning on the water valve,
make sure that there is no leakage at both
connection points of the water pipe. In case
of a leak, turn off the valve immediately and
tighten all joints again using a spanner or a
pair of pliers.
11
Connection of the Water Pipe to the Cold Water Mains Line
Figure A
Figure C
EN
