14
Models RD30/RC25Operating Procedures
Place the door spout seal o- ring into the groove in the
door and lubricate the components.
Figure 14
Align the draw spout assembly with the door. Place the
draw s pout mounting plate over the draw spout
assembly and align the holes.
Figure 15
Using the thumb screws, fasten the draw s pout
assembly and draw spout mounting plate to the door.
Figure 16
Place the large o- ring into the groove on the back side
of the door and lubricate the installed o- r ing.
Figure 17
Place the door bearing onto the hub on the back side
of the door with the flanged end of the bearing facing
the door .
Note: Do not lubricate the door bearing.
Step 5
Install the freezer door. Position the dooron thefreezer
studs at the f ront of t he freezing cylinder . Press the
door firmly into place.
Note: The torque rotor will protrude through the hole
in the center of the door.
Figure 18
