OPTIONAL PIPE BAND MOUNTING WITH QZ02L SENSOR
Install the stainless steel pipe band with the sensor
mounting bracket at the invert (bottom) of the pipe. Ensure
that the sensor bracket is parallel to the water surface
(check with a level). Mount so the tapered end of the
sensor will point upstream and the sensor cable will point
downstream. (Turn the ¼” hex nut clockwise to expand the
bracket and secure to the pipe wall by friction fit.)
Insert the sensor into the mounting bracket and clip or tie wrap the sensor cable securely to the stainless
steel pipe band as illustrated.
ENCLOSURE INSTALLATION
Close the Stingray cover and ensure that the sensor cable connector is tightened snugly for a watertight
seal (do not damage the connector by over tightening the coupling). Wipe the enclosure cover gasket
with a clean cloth to remove dirt or grit before closing.
Use a chain or mounting bracket to hang the enclosure from the manhole ladder or any available secure
location. The enclosure should be located above the high water level so that it will not be accidentally
submerged.
Stingray is rated for operation from -20°C to 60°C (-4°F to 140°F). The batteries will not function below
the rated temperature. To prevent overheating, avoid mounting the enclosure in direct sunlight.
Stingray enclosure is rated IP67, watertight and dustproof.
Page 9
Stingray Level-Velocity Logger
Manual Series A.3
DETAIL
BAND ADJUSTMENT
JACK
VSJ PIPE MOUNTING BAND
BAND
ADJUSTMENTJACK
SENSORMOUNTING
BRACKET
