10
-EN
Getting Started
Connecting a camcorder
Use this connection to view a camcorder picture.
AUDIO-L (white)
AUDIO-R (red)
VIDEO
(yellow)
VMC-810S/820S
(not supplied)
Video and
audio outputs
Note
• To connect a monaural camcorder, connect the audio output of
the camcorder to AUDIO-L (MONO) of VIDEO 2 INPUT on
the projection TV.
(Front of projection TV)
Connecting an audio system
When connecting audio equipment, see page 28 for
more information.
AUDIO OUT-L
(white)
AUDIO OUT-R
(red)
RK-74A (not supplied)
Set the amplifier’s
function to line input.
(Rear of projection TV)
Line
input
Note
• You can adjust the bass, treble, and balance, or select surround
(page 26) or an MTS (Multichannel TV Sound) mode (page 27)
with the supplied remote control.
Stereo amplifier
Connecting two VCRs for tape editing using MONITOR OUT
You can record input images displayed on the screen.
This type of connection should be used only when you
connect from the line input of one VCR, and from the
line output of a second VCR.
Notes
• Do not change the input signal while editing through
MONITOR OUT, or the output signal will also change.
• You can use the S video jack to connect a VCR for playback
and the composite video connector to connect a VCR for
recording.
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
(Rear of projection TV)
VCR (for playback)
VCR (for recording)
VMC-810S/820S
(not supplied)
VMC-810S/820S
(not supplied)
• When connecting a single VCR to the projection TV, do not
connect the MONITOR OUT to the VCR’s line input, while at
the same time connecting from the projection TV’s VIDEO IN
connectors to the VCR’s line output, as shown below.
(Rear of projection TV)
DO NOT CONNECT IN THIS WAY.
Video and audio
outputs
Video and audio
inputs
