8
8
66
This chapter describes how to replace the toner cartridge and how to clean the unit.
TONER CARTRIDGE REPLACEMENT
When the toner cartridge replacement required ( ) indicator lights up, replacement
of the toner cartridge will be needed soon. Obtain a new cartridge. When the toner
cartridge replacement required ( ) indicator blinks, the toner cartridge must be
replaced before copying can be resumed. Replace the toner cartridge by following
the procedure below.
1
Open the multi-bypass tray,
and then open the side
cover while pressing the
side cover open button.
2
Push gently on both sides of the
front cover to open the cover.
Be sure to use only genuine SHARP parts and supplies.
• After the unit stops, it may be possible to make a few more copies by
taking the toner cartridge out of the unit, shaking it horizontally, then
reinstalling it. If copying is not possible after this operation, replace the
toner cartridge.
• During long copy run of a dark original, the start ( ) indicator may
blink, the indicator light up, and the unit stop, even though toner is left.
The unit will feed toner up to 2 minutes and then the start ( )
indicator will light up. Press the start ( ) key to restart copying.
MAINTENANCE
