Setting
45
Ceiling
When this function is "On", the picture is top/bottom
and left/right reversed. This function is used to project
the image from a ceiling mounting the projector.
Rear
When this function is "On", the picture is left/right
reversed. This function is used to project the image to
a rear projection screen.
Ceiling
Rear
Input search
This function detects the input signal automatically.
When finding a signal, the search will stop. Use the
Point
◄► buttons to select one of the following.
Off Input search does not work.
On1 Input search works
under the situation below.
• When pressing the INPUT button on the top
control.
•
When pressing the COMPUTER button or
VIDEO button on the remote control.
On2 Input search works under the situation below.
• When turning on the projector with pressing
the POWER ON/STAND-BY button on the
top control or on the remote control.
•
When pressing the COMPUTER button or
VIDEO button on the remote control.
• When missing the current input signal.
*
• When pressing the INPUT button on the top
control.
Note:
• While Input search is set On1 or On2, the status of Input and Lamp are displayed every time the
signal is switched.
•
Only the input source selected at the last time can be detected.
• If any of the INPUT button on the top control or COMPUTER/VIDEO button on the remote
control is pressed while Input search is on, Input search will stop.
*If the No show or Freeze function is active, cancel it
to activate the Input search. It is also unavailable when
On-Screen menu is displayed.
Terminal
The
COMPUTER IN 2/MONITOR OUT terminal on the
back of the projector is switchable for computer input
or
monitor output. (See page 9) Select Computer 2 or
Monitor out with the Point ◄► buttons.
Computer 2......computer input
Monitor out.......monitor output
Terminal function is not available when selecting
Computer
2 to the input source. Change the input
source to the others (Computer 1 or Video) so that the
Terminal function will be available.(p.25, 34, 35)
