Sanyo PLC-XTC50AL Manual

A SERVICE OF

next previous

52

Setting

Set the red frame pointer

to the item and press the

SELECT button.

Use the Point

ed buttons

to set the Lamp mode.

Select from (Lamp1, Lamp2

or Lamp 1/2).

Select [Yes] to

activate it.

This Projector is equipped with 2 Projection Lamps. This

function allows you to choose how to use the lamp as follows.

Lamp1............Always use Lamp 1.

Lamp2 ........... Always use Lamp 2.

Lamp1/2......... Automatically switch the active lamp from one

lamp to the other .

✔Note:

 •WhenLamp1orLamp2modeisswitchedtoLamp

1/2mode,theactivelampchangesafterthetotal

lightingtimeofacurrentlyusedlampexceeds10

hours.

 •Whenthetotallightingtimeofonelampexceeds

therecommendedtotalhoursofuseintheLamp1/2

mode,theLampmodewillbeswitchedtoLamp1or

Lamp2modeautomatically.Switchingoperationis

donewhenthelampischanged.

 •Lampmodecannotbechangedforawhileafter

turningontheprojector.Lampneedssometimeto

stabilizeafterthepoweristurnedon.Storedlamp

modewillbeactiveafterthelampisstabilized.

•Whenthedifferentlightingtimeofthelampslight

alternately,youmayrecognizedifferentbrightness

andwhitebalanceoneachdifferentlightingtimeof

lamps.

  Whenyouchangetheotherlamp,werecommend

youalwaysusetheotherlampwhichisnotchanged.

 •WhentheTimerissetto“Off”andthetotallighting

timeofonelampexceeds10hoursofuseinthe

Lamp1/2mode,onelampwillbeswitchedtothe

otherlampautomatically.Switchingoperationis

donewhentheprojectoristurnedOffandOn.

 •WhentheprojectorisswitchedtoOff/On(including

Standby),Timersettingisresettooff.

 •WhentheTimerissetto“On”intheLamp1/2mode,

  theLamptimercounterisdisplayedontherightside

oftheLampmodeintheInformationmenu.(p.30)

Lamp mode

The following items can be selected.

Timer setting :

............Switch the timer to On/Off.

Start .........Time to start timer.

(0-24 hours)

Lamp interval . .Time to lamp change.

(1-24 hours)

When selecting Lamp1/2 mode

Use the Point 7 8 buttons to

select items and press the

SELECT buttons.

Select [Yes] to

activate it.

✔Note:

  •The Lamp timer counter appears with

the Lamp status before 10 seconds

when the Lamp will be switched.

Timer setting