10
Part Names and Functions
Rear Terminal
⑥ S-VIDEO IN
Connect the S-VIDEO output signal from video
equipment to this jack (p.16).
⑨ AUDIO IN
Connect the audio output signal from video
equipment connected to ⑥ or ⑩ to this jack.
For a mono audio signal (a single audio jack),
connect it to the L (MONO) jack (p.16).
⑧ COMPUTER 1 COMPONENT / COMPUTER 2
AUDIO IN
Connect the audio output (stereo) from a
computer or video equipment connected to ②,
③ or ④ to this jack. (pp.15, 17)
⑩ VIDEO IN
Connect the composite video output signal to
this jack (p.16).
② COMPUTER IN 1 / COMPONENT IN
Connect output signal from a computer, RGB scart
21-pin video output or component video output to
this terminal (pp.15,17).
⑦ AUDIO OUT (VARIABLE)
Connect an external audio amplifier to this jack
(pp.15 -17).
This terminal outputs sound from AUDIO IN terminal
(⑧ or ⑨).
Never plug headphones and earphones into AUDIO
OUT jack.
⑤ LAN Connection Terminal
Connect the LAN cable (refer to the owner’s manual
of “Network Set-up and Operation”).
② ③① ④
⑦
⑧⑨
① CONTROL PORT
When controlling the projector with RS-232C,
connect the control equipment to this connector with
the serial control cable.
⑩
⑤
⑥
④ HDMI
Connect the HDMI signal (including sound signal)
from video equipment or the DVI signal from
computer to this terminal (pp.15, 17).
③ COMPUTER IN 2 / MONITOR OUT
– Connect computer output to this terminal (p.15).
– This terminal can be used to output the incoming
analog RGB signal and component signals from
COMPUTER IN 1/COMPONENT IN terminal to the
other monitor (p.15).
*
is registered trademarks of HDMI
Licensing, LLC.
*
