A SERVICE OF

logo

Open as PDF
next previous
Setting
Simple mode buttons
Only these buttons are
active when the simple
mode is set to On. [ON,
STAND-BY, SHUTTER,
INPUT, MENU, AUTO
PC, SCREEN, SELECT
(Mouse Pointer
included), L-CLICK,
R-CLICK, P-TIMER,
POINTER, PIP, ON-OFF
switch] Number buttons
(p.14) also become
active only when setting
the remote control codes
numbers or entering the
PIN code numbers (pp.
56, 66).
This function decides whether to activate the simple mode.
Off . . . Simple mode function is off.
On. . . . Only the simple mode buttons are active.
The eight different remote control codes (Code 1- Code 8)
are assigned to the projector; the factory-set, initial code
(Code 1) and the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and
the remote control. For example, operating the projector in
Code 7, the remote control code also must be switched to
Code 7.
To change the code for the projector:
Select a remote control code in this Setting Menu.
To change the code for the remote control:
Press and hold the MENU button and a number button
(1-8) on the remote control for more than five seconds to
switch among the codes. See “Remote Control Code” on
page 16.
Note:
•Whendifferentcodesaresetontheprojectorandon
theremotecontrol,nooperationcanbemade.Inthat
case,switchthecodeontheremotecontroltofitthe
codeontheprojector.
•Ifthebatteriesareremovedfromtheremotecontrol
foralongperiodoftime,theremotecontrolcodewill
bereset.
Simple mode
Remote control
Note:
WarningiconandSimple mode : Onmessageappear
onthescreenforabout4secondswhenpressthe
buttonwhichisnotthesimplemodebutton.
RC sensor
62
Select a location of the infrared remote receiver of the
remote control. See “Remote Control Receivers and
Operating Range” on page 15 for details.
Both .... Activate both the front and back receiver.
Front ... Activate only the front receiver.
Back .... Activate only the back receiver.