Setting up your French Door Refrigerator
INSTALLING THE WATER LINE
There are several items that you need to purchase to complete this connection.
You may find these items sold as a kit at your local hardware store.
Slip the compression nut ( ) through the supplied plastic tubing ( ).
Tighten the compression nut ( ) onto the 1/4” compression fitting.
If you are using copper tubing, slip the compression nut ( ) (not supplied) and ferrule (not supplied)
on copper tubing (not supplied) as shown.
If you are using plastic tubing ( ) , insert the molded end(Bulb) of the plastic tubing ( ) into the
compression fitting.
Do not use without the molded end(Bulb) of the plastic tubing ( ).
Tighten the compression nut ( ) onto the compression fitting.
Do not over-tighten the compression nut ( ) .
Turn water on and check for any leakage.
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 1/4“ of the plastic tubing to make sure you
get a snug, leak-free connection.
Plastic tubing
(A) (Supplied)
Ferrule (Not
supplied)
Compression
nut (A) (1/4”)
(Supplied)
Compression
fitting (Supplied)
Molded
end(Bulb)
Compression nut
(B) (1/4”) (Not
supplied)
or
Copper tubing
(Not supplied)
Plastic tubing (B)
(Not supplied)
Household water supply line
Refrigerator
Use Copper Tubing Use Plastic Tubing
¼” copper tubing
¼” compression nut (2pc)
Ferrule (2pc)
¼” plastic tubing
→
Molded end(Bulb)
¼” compression nut (2pc)
CAUTION
