Understanding Your Contacts 38
To look up information for a
specific contact:
1. In standby mode, press
and hold to
launch VoiceSignal.
“
Say a Command
”
appears in the display
and is pronounced through the speaker.
2. Say “
Lookup
”.
VoiceSignal prompts
you to “
Say the name.
”
3. Speak clearly and say
the full name of the
person you want to call,
exactly as it is entered
in your Contacts list.
•
If VoiceSignal recognizes the name you said, the Contact entry
information for that name appears in the display.
•
If VoiceSignal does not recognize the name you said, a choice list of
up to three names appears in the display, and VoiceSignal prompts
you with “
Did you say?
” followed by the first name on the list.
4. Say “
Yes
” to confirm the name or “
No
” to hear the next
name, or use the keypad to select the correct name from
the list. (For more information, refer to “Choice Lists” on
page 96.)
•
To say the name again, press
Repeat
.
•
To exit VoiceSignal without dialing, press
Settings
and press
Exit
.
5. The contact information
for the name you
selected appears in the
display.
•
To dial the default number
associated with the name,
press .
•
To remove this entry from
your Contacts list, press the
Erase
soft key.
•
To add or change information for this entry, press
EDIT
().
•
To access the following options, press the
Options
soft key.
–
Send Txt Msg
— Create and send a text message to the selected
Contact.
–
Send Pic Msg
— Create and send a picture message to the selected
Contact.
–
Call
— Dial the number associated with the Contact name.
