Pathfinder Radar Scanners iii
Preface
This handbook describes the following Raytheon Pathfinder radar
scanners:
2D 18" 2 kW Radome Scanner
4D 24" 4 kW Radome Scanner
5S 48" 4 kW Open Array Scanner
7S 72" 4 kW Open Array Scanner
9S 48" 10 kW Open Array Scanner
11S 72" 10 kW Open Array Scanner
These scanner units may be connected to any HSB display unit. In
addition, the 2D and 4D radome scanner units may be connected
to SL70, or Autohelm 7" LCD display.
CAUTION:
The open array scanners must not be used with the SL70 or
Autohelm 7" LCD Display Unit. This may result in damage to the
display due to the high power requirements of the open array
scanner.
The handbook contains very important information on the instal-
lation and operation of your new equipment. In order to obtain the
best results in operation and performance, please read this hand-
book thoroughly.
Raytheon’s Product Support representatives or your local dealer
will be available to answer any questions you may have.
Display Software Version
For full operation of the open array scanners, the display unit
requires an appropriate software version. For new displays, the
correct software version is normally already installed in the dis-
play unit and is fully compatible with the 2D and 4D radome
scanners.
Early display units may not have the correct software for use with
open array scanners and will therefore require upgrading.
The software version can be confirmed by switching-on the dis-
play and checking the version number during the magnetron
warm-up sequence.
154_4.book Page iii Wednesday, October 25, 2000 3:02 PM
