A SERVICE OF

logo

Open as PDF
next previous
2323
If you experience a problem with your
projector, please refer to the following
information. If a problem persists, please
contactyourlocalretailerorservice
center.
Image Problems
No image appears on-screen
•Ensurethecables/charger/
battery are correctly and securely
connected.
•Ensurethepinsofconnectorsare
not crooked or broken.
•Makesuretheprojectoris
switched on.
Image is out of focus
•AdjusttheFocusDial.
•Makesuretheprojectionscreen
is between the required distance
9.6 to 126.6 inches (0.245 to 3.215
meters)fromtheprojector.See
page 5.
Image is too small or too large
•Movetheprojectorclosertoor
further from the screen.
Imageisreversed
•Select“Setup-->Display-->
Projection” from the OSD and set
the projection direction.
Audio Problems
No sound
•Duringvideoormusicplayback,
press the button.
Battery Problems
Battery capacity is low
•Removethebatteryandcleanthe
connectors.
•Thebatteryiswornoutandneeds
to be replaced.
•Thebatterymaynotcharge
correctly after the projector
is turned off due to the high
temperature emitted by the
projector. Let the projector cool
for a while before connecting the
charger.
LED Indicator
LED Color
Description
No light In operation
Red Battery charging
Green Battery charging
trouBleShootIngcompatIBle vIDeo / vga moDe
Timing Table
Mode Resolution V-Sync(Hz)
VGA
640x480 60
800x600 60
1024x768 60
1280x720 60
1280x800 60
1024x600 60
Composite*
Component
HDMI
480i / 480P 60
576i / 576P 50
720p 50 / 60
1080i 50 / 60
<Note>
Video format does not support content with
B-Frame function.
<Note>
• TheLEDashesredwhenthe
projector temperature reaches 80°C.
It is recommended to switch off the
projector to allow it to cool down.
• When the projector temperature
reaches 85°C, the projector
automatically shuts down due to the
built-in temperature protection. This is
not a malfunction. Let the projector cool
down before switching it on again.
hoW to uploaD fIleS to Internal memory
WhenacomputerisconnectedviaUSB,theprojectorautomaticallydetectsthe
connection and the message below appears on screen.
Video Music Photo
Input Office Viewer Setup
Press matched symbol to enter specific function directly
Yes
No
<Note>
Displayedscreenvaries
depending on the last session.
Returnstothepreviousscreen
1.
Confirm Transfer
<Note>
The screen turns black after 60 seconds for
powersaving.Press
to wake up the display.
or
2.
Upload Files by Computer
3.
Unplug the USB Cable
<Note>
Check your computer for the upload status.
When upload is complete, you must unplug the
USB cable to display the Home menu.