11
Before Using the DV-SP502/DV-SP502E
Notes:
• The supplied batteries should last for about six
months, although this will vary with usage.
• If the remote controller doesn’t work reliably, try
replacing both batteries.
• Don’t mix new and old batteries, or different types of
batteries.
• If you intend not to use the remote controller for a long
time, remove the batteries to prevent possible leakage
and corrosion.
• Flat batteries should be removed as soon as possible to
prevent possible leakage and corrosion.
To use the remote controller, point it at the DV-SP502/
DV-SP502E’s remote control sensor, as shown below.
Notes:
• The remote controller may not work reliably if the
DV-SP502/DV-SP502E is subjected to bright light,
such as direct sunlight or inverter-type fluorescent
lights. Keep this in mind when installing the DV-
SP502/DV-SP502E.
• If another remote controller of the same type is used in
the same room, or the DV-SP502/DV-SP502E is
installed close to equipment that uses infrared rays,
the remote controller may not work reliably.
• Don’t put anything, such as a book, on the remote con-
troller, because the buttons may be pressed inadvert-
ently, thereby draining the batteries.
• The remote controller may not work reliably if the
DV-SP502/DV-SP502E is installed in a rack behind
colored glass doors. Keep this in mind when installing
the DV-SP502/DV-SP502E.
• The remote controller will not work if there’s an obsta-
cle between it and the DV-SP502/DV-SP502E’s
remote control sensor.
Installing the Batteries
1
Open the battery compartment, as shown.
2
Insert the two supplied batteries (AA) in
accordance with the polarity diagram
inside the battery compartment.
3
Close the battery compartment.
Using the Remote Controller
R
E
T
U
R
N
S
E
T
U
P
TOP
M
E
N
U
M
E
N
U
C
U
R
S
O
R
P
U
S
H
T
O
E
N
T
E
R
DV
-
S
P
5
02
S
UPER
A
U
DIO
CD &
D
VD
AUDI
O
/
V
ID
EO P
LA
Y
E
R
P
RO
G
R
E
SS
IV
E
S
C
A
N
P
R
OG
R
E
S
S
I
V
E
30˚
30˚
Approx. 16 ft. (5 m)
Remote control sensor
DV-SP502/DV-SP502E
