Printer Power Connection
1. Plug the output of the power module provided with the printer into
the connector on the rear panel.
2. Plug the power module into an AC outlet having the proper voltage.
3. Place the power switch in “I” position to turn on the power.
Note
If the FEED button is pressed after a label is printed, the last
label will be
printed again; otherwise a blank label is fed. To
clear the image buffer inside the printer press and hold the
FEED button for at least 5 seconds until
l the ERROR indicator
is lit, then release the FEED button.
Important !
The required AC voltage is marked on the power supply.
Confirm that your AC voltage matches the power supply input
specificaton.
Do not use any power supply other than the one
provided with the printer.
Printer Interface Connection
1. Connect the interface cable to the parallel printer port on the
computer.
2. Connect the other end to the parallel input port on the printer.
.
6
