3 way active, with mono bass
The PAB 5400 5 channel amplifi er contains all the functions neces-
sary to set up a completely self contained 3 way active crossover
Interconnect cable checklist:
Use good quality RCA cables to connect the inputs of channels 1&2
to the full range outputs of the source.
Switch setting checklist:
Crossover frequency control checklist:
- CH 1/2 HIGH PASS: 1KHz to 4KHz
- CH 3/4 HIGH PASS: 100 Hz
- CH 3/4 LOW PASS: 1KHz to 4KHz
Note that the HIGH and LOW PASS controls of channels 3&4 act as
Please note that these frequency points are suggestions only. Refer to
the loudspeaker manufacturer specifi cations and the section “Setting
up systems after installation for best performance”
Refer to the section “Setting up systems after installation for best
Minimum fi nal loudspeaker impedances:
Front/rear high pass, with constant
Another obvious application for the PAB5400 is to use 4 channels for
front/rear satellites, and the mono channel for constant non faded
Interconnect cable checklist:
Use good quality RCA cables to connect channels 1,2,3&4 inputs to
the front and rear outputs of the source as shown.
Switch setting checklist:
Crossover frequency control checklist:
- CH 1/2 HIGH PASS: 100 Hz
- CH 3/4 HIGH PASS: 100 Hz
Please note that these frequency points are suggestions only. Refer to
the loudspeaker manufacturer specifi cations and the section “Setting
up systems after installation for best performance”
Refer to the section “Setting up systems after installation for best
Minimum fi nal loudspeaker impedances:
AMPLIFIER APPLICATIONS
PAB 5400 5-Channel Amplifi er
