28
Setting items Setting contents Default
3DNR
Reduces noise in the entire picture.
0 – +3 0
BNR
Reduces the block noise generated by digital
processing.
0 – +3 0
MNR
Reduces the noise around the outline of an
object generated by digital processing.
0 – +3 0
Contrast
Adjusts picture contrast.
–6 – +6 0
Brightness
Adjusts picture brightness.
0 – +12 0
Gamma Correction
Changes the amount of gamma correction to
adjust overall brightness of a picture.
Make Dark(–) / Bright(+) section easier to see.
–4 – +4 0
Sharpness
Adjusts picture sharpness for the higher
frequency range.
–6 – +6 0
Hue (color tone)
Adjusts the green and red color balance.
–6 – +6 0
Chroma Level
Adjusts the color density.
–6 – +6 0
Settings enabled during playback
Adjusting the picture quality (Picture control)
You can adjust the picture quality to your liking.
The adjusted values can be stored in Memory 1 through Memory 5.
1
Press PICTURE ADJ.
The currently set status is displayed.
3DNR
Brightness
MNR
BNR
Contrast
Gamma Correcti...
0
Memory1
2
Press ui to select a memory number to be used, and then press ENTER.
3
Press ui to select an item then press ENTER or p.
4
Change the setting with ui.
•Refer to the table on the right for information on the different settings.
n To finalize picture adjustments
Press PICTURE ADJ. after adjusting.
•The pop up menu of the picture adjustments is disappeared on the screen.
The picture adjustment settings are retained in memory even after the power is turned off.
NOTE
During 3D playback, you cannot adjust “Video resolution” (vpage27) or “Adjusting the picture quality
(Picture control)” (vpage28).
