143
Appendix
TipsSettingsConnections
Contents
Front panel Display Rear panel IndexRemote
Playback
Remote lock function
When connecting an IR receiver, enable the Remote lock function. When
the function is enabled, you can not perform operations with the remote
control unit.
By default, this function is disabled.
ui ENTER
BACK
X
Disabling the sensor function of the
remote control unit
1
When the main unit is in standby mode, press X while
holding down BACK and ENTER on the main unit.
2
Press ui to select “RC LOCK On”.
3
Press ENTER to enter the setting.
The infrared light receiving function is disabled.
Enabling the remote sensor function
1
When the main unit is in standby mode, press X while
holding down BACK and ENTER on the main unit.
2
Press ui to select “RC LOCK zO”.
(z The currently set mode.)
3
Press ENTER to enter the setting.
The infrared light receiving function on the main unit is enabled.
