NAMES AND
FUNCTIONS
12
BASIC
CONNECTIONS
BASIC
OPERATION
ADVANCED
CONNECTIONS
SETUP
ADVANCED
OPERATION
TROUBLESHOOTING
OTHERS
BASIC
CONNECTIONS
ENGLISH
BASIC CONNECTIONS
CONNECTING AUDIO COMPONENTS
The output audio signal from the CD/CDR OUT jack is the same signal which is currently selected.
ANALOG AUDIO
CD/CDR
IN
OUT
L
R
REC/ZONE B
OUT
IN 2
OUT IN
L
R
L
R
DIGITAL
INPUT
DIGITAL
OUTPUT
R LRL
R L RL
L R
CD recorder
Analog Audio
Digital Audio (coaxial)
Digital Audio (optical)
Notes
• Do not connect this unit and other components to mains power until all connections between components have
been completed.
• Insert all plugs and connectors securely. Incomplete connections may make noise.
• Be sure to connect the left and right channels properly.
Red connectors are for the R (right) channel, and white connectors are for the L (left) channel.
• Be sure to connect input and output properly.
• Refer to the instructions for each component that is connected to this unit.
• Do not bind audio/video connection cables with power cables and speaker cables this will result in generating
a hum or other noise.
CONNECTING DIGITAL AUDIO COMPONENTS
• Refer to the instructions for each component. To setup the digital audio format of CD player, or other digital
source’s connected to digital input jacks.
• Use fi ber optical cables (optical) for optical input jacks and REC/ZONE B optical output jack. Use 75 ohms
coaxial cables (for digital audio or video) for coaxial input jacks.
• You can designate the input for each digital input/output jacks according to your component. (See page
25)
Notes
• The digital signal jacks on this unit conform to the EIA standard. If you use a cable that does not conform to
this standard, this unit may not function properly.
• Each type of audio jack works independently. Signals input through the digital and analog jacks are output
through the corresponding digital and analog jacks, respectively.
