24
NAMES AND
FUNCTIONS
BASIC
CONNECTION
BASIC
OPERATION
ADVANCED
CONNECTIONS
TROUBLESHOOTING
OTHERS
TROUBLESHOOTING
ENGLISH
APPLICATION
OPERATION
TROUBLESHOOTING
USB/iPod
Problem Cause Corrective action
“
OverCurrent
”
appears on
the display.
The voltage able to be supplied from this
unit via the USB has been exceeded.
The USB media is not supported.
Please use a USB device with an
operating current that is less than
500 mA.
“
FAT Error
”
or
“
Cluster Err
”
appear on the display.
An unsupported file system is being
used. USB memory below 128 MB
cannot be supported.
Please use a USB device formatted
w
ith a compatible file system (FAT32
or FAT) and that has at least 256 MB
of memory.
“
No File
”
appears on the
display.
No file able to be played on this unit
exists.
Check supported formats. ( Page
25, 26)
“
DRM Stream
”
appears on
the display.
This is a file subject to digital rights
management.
Cannot play on this unit because of
unsupported DRM. ( Page 25)
The sound of the USB being
connected is not heard.
T
he amplifier and speakers are not
connected properly.
Connect the cables correctly.
( See the instruction manual for the
amplifier.)
The amplifier power is not ON.
Turn the amplifier power ON.
( See the instruction manual for the
amplifier.)
The amplifier
’
s function or selector
switch is not set to
“
CD
”
or
“
AUX
”
or
such (to whatever you have connected
this unit to).
Switch the amplifier
’
s function or
s
elector switch to
“
CD
”
or
“
AUX
”
or
such (to whatever you have connected
this unit to).
( See the instruction manual for the
amplifier.)
The amplifier
’
s volume control is set at
the minimum level.
Adjust the amplifier volume.
( See the instruction manual for the
amplifier.)
The sound of the iPod being
connected is not heard.
3rd generation or earlier iPods are
unsupported.
Refer to
“
ABOUT iPod PLAYBACK
”
.
( Page 26)
The amplifier and speakers are not
connected correctly.
Connect the cables correctly.
( See the instruction manual for the
amplifier.)
The amplifier power is not ON.
Turn ON the power to the amplifier.
( See the instruction manual for the
amplifier.)
The amplifier
’
s function or selector
switch is not set to
“
CD
”
or
“
AUX
”
or
such (to whatever you have connected
this unit to).
Switch the amplifier
’
s function or
s
elector switch to
“
CD
”
or
“
AUX
”
or
such (to whatever you have connected
this unit to).
(See the instruction manual for the
amplifier.)
The amplifier
’
s volume control is set at
the minimum level.
Adjust the amplifier volume.
(See the instruction manual for the
amplifier.)
Reading of USB device
takes time.
When connecting a high-capacity
USB device, it will take time to read
depending on its capacity. Several
m
inutes may be required for reading
when using a high-capacity device.
Wait until reading is completed.
