LXE E-EQ-VX3XDKRG-C-ARC Manual

next previous

Torque Measurement

You will need a torquing tool capable of torquing to 20 inch pounds (1.10 N/m). Torque all screws and bolts according to the

following table:

For these nuts… Torque to

10-32 lock nuts 17 - 20 in/lb (0-95 - 1.10 N/m)

Step 1 – Mount Vehicle RAM Clamp Mount

Components

Assembled

Determine the position for mounting the RAM clamp mount. The clamp mount can be used on a beam (such as on a

fork lift truck) up to 2.5” (63.5 mm) wide and approximately 2” (50.8 mm) thick. The clamp may be attached to a thicker

beam by substituting longer bolts (not included). Be sure to position the RAM clamp mount to allow access to the

switches and ports on the VX3X.

Position the upper clamp piece with ball (A) on the beam. Place the bolts (B) through the holes in the upper clamp

piece.

3. Position the lower clamp piece (C) below the beam. Align the bolts with the holes in the lower clamp piece.

4. Place the nylon locking nuts (D) on the bolts and tighten the bolts.

E-EQ-VX3XDKRG-C-ARC [ 4 ] VX3X Cradle Reference Guide