16
Example of an alarm query
Situation: HACCP ashes in the display.
Display =
Display =
There has not been an alarm status with a
too high or too low temperature. You must
switch to display
.
Display =
Press this button until appears in the display.
Display = 1 power failure has occurred.
Display =
Display =
Last power failure.
Display = Year 2010
Display = Month 05 (May)
Display = Day 30
Display = Hour 23
Display = Minute 14
Display = The power failure lasted 3 hours.
Press
+ for 5 seconds. The display will read .
The HACCP LED will now light up permanently.
The electronic control system is now ready for the next alarm.
Press
for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
Calibrating the control sensor (standard sensor for
temperature control)
Possible tolerances of the control sensor (the displayed tempera-
ture compared to the actual interior temperature) can be oset
with this function.
Press
for 5 seconds. Display =
Display =
Display =
Display = correction value set at the factory
Use buttons
or to increase or decrease the correction value
in 0.1°C increments.
Display = actual (corrected) interior temperature
Display =
Press for 5 seconds.
The electronic control system will switch back to normal operat-
ing mode.
