icomfort Wi−Fit 7−Day Programmable Communicating Thermostat
Page 3
Start up
In event of power failureĊIf a power failure occurs,
when the power comes back on, the thermostat will reboot
and when complete, the HOME screen will return.
What the Home screen tells you...
After the thermostat and the
system has been fully connected
and powered on, the icomfort
Wi−Fit
thermostat’s Home screen is
displayed. Figure 1 shows a
display and describes what the
thermostat is telling you.
Note that set to heat or cool
communicates that the system
is operating in manual
mode;
if it were in program
mode,
the heat or cool button would
read summer program is on
(or other named program).
Other information...
Until and unless the indoor temperature
is at or between the two settings
(70 to 75 degrees in this example), the system
should run until it does measure within that
temperature range.
Wi−Fi" in the bottom lift corner is the button" to access
the Wi−Fi settings screen. Wi−Fi with a
beneath it indicates
a prior connection to the server has been lost. If a connection had
been lost, then re−established, the triangle goes away.
Away mode sets the thermostat for energy saving while you are gone for an
extended period of time. In this mode, the system will only come on if indoor
temperature falls below 62 degrees (for heating) or if indoor temperature rises
above 85 degrees (for cooling).
What you can do from the Home screen...
Typically, what every homeowner wants from an air
conditioning system is to be able to control that
system using a convenient device to
adjust heating, cooling, and the
level of humidity in the home.
From this screen you may:
− adjust temperature
settings
− access menus to change the
program mode
− change how the
fan operates
− access the dashboard" (fig.
3) by pressing
− access and view active ser-
vice alerts by pressing the
icon
− access help screen by press-
ing the ?" icon.
Adjusting the temperature and changing the
system mode of operation is described fully
beginning on Page 14.
Adjusting the humidity, even if no physical humidifier or
dehumidifier is present, may also be available, provided the
installer has implemented the feature during setup.
See Page 16 for details on humidity control.
indoor temperature
indoor humidity is 41%
fan is
OFF
fan is
AUTO
cool−to
set temp
75
heat to
70
heat
or
cool
fan is
AUTO
away
mode
outdoor
temperature
80
press to go
to user
dashboard
use arrows
to change
temperature
indoor
temperature
indoor
humidity
outdoor temperature
cool−to settingheat−to setting system mode
system status
fan is set
to AUTO
service alerts are presenttime, month, day, year
(if feature is turned on)
(if feature
is
turned on)
Figure 1. Home screen (typical)
Wi−Fi setup
button
system is cooling
9:39 am January 23, 2012Wi−Fi
?
