Bypass Tray Paper Empty The bypass tray has run out of paper.
Load paper to the bypass tray. See Loading
Paper in the Bypass Tray .
Cannot Copy 2in1/4in1-
Copy Only Support A4/LT/LG
2-in-1 or 4-in-1 copy could not be
performed because the tray does not
contain the valid size paper, which
are A4, Letter, or Legal size.
● Set the machine to print copies
using the A4, Letter, or Legal size
paper in the [Paper Select] setting.
See
Copy Settings .
● Specify the A4, Letter, or Legal size
paper for the tray selected for
printing copies in the [Paper Size]
setting. See
Machine Settings .
Cannot Copy Insert Paper to
ADF
2-in-1, 4-in-1, 2-sided, or sort copy
could not be performed because the
originals were not placed in the ADF.
● Use the ADF, even when copying a
single sheet.
● If you need to use the exposure
glass, turn off [2in1], [4in1],
[Duplex Copy], or [Sort] under copy
settings, and then try again. See
Copy Settings .
Connection Fail
The line could not be connected
correctly.
● Confirm that the telephone line is
properly connected to the machine.
● Disconnect the telephone line from
the machine, and connect a
standard telephone in its place.
Confirm that you can make calls
using the telephone. If you cannot
make calls this way, contact your
telephone company.
C toner Independent-supply
A non-supported print cartridge is
installed.
Contact your service representative.
Cover Open
A cover is open.
Close the cover completely.
Dial Fail The fax could not be sent.
● Confirm that the fax number you
dialed is correct.
● Confirm that the destination is a fax
machine.
● Confirm that the line is not busy.
● You may need to insert a pause
between dial digits. Press the
[Pause/Redial] key after, for
example, the area code.
Density Sensor Require
Cleaning
The machine failed to adjust color
registration.
Clean the toner density sensor. See
Cleaning the Toner Density Sensor .
